Instructions for programming
BB01 Board functions
19
© SandenVendo
The display will show a "
PR 1
" message where the "
1
" indicates the column. Using UP and
DOWN buttons will cycle through available column prices. Activation of the ENTER button
will allow access to the displayed column current price. Using UP and DOWN button will
increase or decrease the price by one lowest coin value respectively.
Activation of the ENTER button while the desired price is displayed will save that price.
Activation of the HOME button while a column price is displayed, without doing an ENTER
before will return the VMC to the column display without saving the displayed column
price. Activation of the HOME button while a column is displayed will return the VMC to the
"
PRIC
" prompt. Activation of the HOME button returns the VMC to the normal door open
state.
If the single price mode has been enabled (see "CONF" routine), the price entered
for column 1 will be used for all other column.
5.4 Space to sales setting routine
The VMC feature the ability to assign each of selection button to one of any column.
If the correct password is entered and the ENTER button is activated at the "
STOS
"
prompt the VMC will enter the space to sale setting routine. The display will show the "
SL
1
" which is the first selection switch, using the UP and DOWN button will cycle through
available selections. Activation of the ENTER button will allow access to the columns
assigned to that selection. The display will show "
CO X
" where X is the column number
using UP and DOWN button will cycle through available columns.
Activation of the ENTER button while the configuration is displayed will save that
configuration. Activation of the HOME button while configuration is displayed, without
doing an ENTER before, will return the VMC to the "
SL X
" display without saving the
displayed configuration.
Activation of the HOME button from the "
SL X
" prompt will return the VMC in "
STOS
"
prompt.
If there is less than 10 selections (on the door) the selection that doesn’t exist must
be set to “-----“
5.5 Machine configuration setting routine
If the correct password is entered and if the ENTER button is activated at the "
CONF
"
prompt the VMC will enter the machine configuration setting routine. The display will show
a "
C1
" message where the "
1
" indicates configuration setting number 1. Using UP and
DOWN button will cycle through the available configuration setting numbers. Activation of
the ENTER button while a configuration setting number is displayed will allow access to
the current setting number of the displayed configuration setting.
Activation of the ENTER button will save the displayed configuration. Activation of the
HOME button while configuration is displayed, without doing an ENTER before, will return
the VMC to the "
CONF
" display without saving the displayed configuration. Activation of
the HOME button returns the VMC to the normal door open state.
(*) Parameters C2 to C3 have different function in MDB and Executive protocol.
Parameters C4 to C10 are only used for MDB protocol. In the Executive protocol
these parameters are directly setting in the changer.
