Instructions for programming
BB01 Board functions
17
© SandenVendo
4.1.6 Chute sensor error routine
If the ENTER button is activated at the "
CHUT
" prompt the VMC will display a "
CS
"
message indicating a chute sensor error.
If the ENTER button is pressed and held for two seconds during the "
CS
" error code, that
code will be cleared.
After clearing VMC will display the next error, or "
NONE
" if no other error.
Activation of HOME button will return the VMC to the code level at the "
EROR
" message.
4.1.7 Bill Validator error routine
If the ENTER button is activated at the
"BUAL"
prompt the VMC will display a
"BC"
message indicating a bill validator communication error, a
"BFUL"
message indicating
that the bill stacker is full, a
"BILL"
message indicating a defective motor, a
"BJ"
message indicating that there is a bill jammed in the bill validator, a
"BRCH"
message
indicating a checksum error, a
"BOPN"
message indicating an open cash box, or a
"BS"
message indicating a bill sensor error. The first column that has been detected with a
home sense error.
Using the UP or DOWN buttons will cycle through all bill validators errors. If the ENTER
button is pressed and held for two seconds during the display of any error code that code
will be cleared. After clearing VMC will display the next existing error, or
"NONE"
if no
other error. Activation of HOME button will return the VMC to the code level at the
"EROR"
message.
4.2 Coin payout routine
If the ENTER button is activated at the
"CPO"
prompt the VMC will enter the coin payout
routine. Upon entry into this routine the display will show the lowest coin value
dispensable.
Pressing the UP button will increase the display to the next highest coin value, the DOWN
will decrease to the next lowest coin values. When the changer has only 3 tubes, the
fourth value will display to 0, means don 't exist the fourth tube.
Pressing the ENTER button will payout the displayed coin type. Activation of the HOME
button while a coin value is displayed will return the VMC to the
"CPO"
prompt.
Pressing button 5 will display the coins present in the TUBE
Activation of the HOME button at the
"CPO"
prompt returns the VMC to the " normal mode
door open state.
4.3 Tube fill routine
If the ENTER button is activated at the
"TUFL"
prompt the VMC will enter the tube fill
routine. The purpose of this routine is to allow the operator to fill the tubes by entering
them through the acceptor and thus have total coin accountability, if they so choose.
Upon entry into this routine the VMC will enable acceptance of any coin type that will be
routed to an inventory tube and disable all others.
The VMC will count and display all inventoried coins and will not disable the acceptor from
taking coins when the highest price setting is reached. Activation of HOME button while a
coin inventory is displayed will return the VMC to the
"TUFL"
prompt. Activation of the
HOME button at the
"TUFL"
prompt returns the VMC to the normal mode door open state
BBMDEX 5.15 can manage 5 tubes
