S&C Instruction Sheet 1069-500
9
Setup and Installation
Figure 4. IntelliCom WAN Mesh Radio power and Ethernet connectors.
Figure 5. IntelliCom WAN Mesh Radio antenna connectors.
Power Connection
Connect the ac power cable to ac power and to the IntelliCom WAN Mesh Radio. Refer to
Figure 4, from left to right: ac power, dc power, Ethernet Port 3 (PoE), Ethernet Port 2
(PoE), Ethernet Port 1 (no PoE), USB (not used).
Bottom row, from left to right: Reset button (under threaded cap), Power LED, Status
LED, Radio 1 Mesh LED, Radio 2 Mesh LED, Ethernet.
Ports 2 and 3 can provide IEEE 802.3af PoE functionality to powered devices connected
to these ports. Port 1 cannot supply power.
Powering Other
Ethernet Devices
When connecting antennas, connect them in numerical order 1-2-3. If you are not using
three antennas per radio, do not skip antenna connectors. Refer to Figure 5, from left
to right: Antenna 1, antenna 2, antenna 3. The antenna 1 connector is at the top of the
unit (farthest from the power and Ethernet connections) on both the left and right sides.
Connecting Antennas
