S&C Instruction Sheet 1069-500
13
Regulatory Information
FCC Radiation Exposure Statement
To ensure compliance with the FCC’s radio frequency exposure limits, the antenna used
for this transmitter must be installed to provide a separation distance from all personnel.
The distance must be 76 cm.
The transmitter must not be co-located or operated in conjunction with any other
antenna or transmitter. Installers and end users must follow these installation instructions.
FCC Canadian Compliance Statement
This Class A digital apparatus meets all Canadian Interference-Causing Equipment
Regulations.
Cet appareil numerique de la classe A respecte les exigences du Reglement sur le
material broilleur du Canada.
This device complies with Class A Limits of Industry Canada. Operation is subject to
the following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may
cause undesired operation.
S&C IntelliCom
®
Mesh Radios are certified to the requirements of RSS-210 for 2.4
and 5 GHz spread spectrum devices. The use of this device in a system operating either
partially or completely outdoors may require the user to obtain a license for the system
according to the Canadian regulations. For further information, contact your local
Industry Canada office.
Canadian units will not transmit in the 5600–5650 MHz band.
DFS Notice
IntelliCom WAN Mesh Radio devices are subject to Section 15.407 of FCC rules and are
required to implement radar detection and DFS functions. They are DFS-certified, and will
not transmit on channels which overlap the 5600–5650 MHz band (channels 120, 124, 128).
Devices intended for outdoor use are further restricted, as follows:
Any installation of a device within 35 km of a Terminal Doppler Weather Radar (TDWR)
location shall be separated by at least 30 MHz (center-to-center) from all TDWR operating
frequencies (as shown in Table 3 on page 14).
Procedures for the installers and the operators on how to register the devices in the
industry-sponsored database with the appropriate information regarding the location
and operation of the device and installer information is included.
