1.
With the ignition switched off and the
parking brake set, disconnect the negative
battery terminal from both batteries.
INSTALLATION INSTRUCTIONS
VEHICLE APPLICATION
Year: 2011-16
Make: Ford
Model: F-250, F-350
Engine: 6.7L Diesel
TOOLS REQUIRED
• 8mm Wrench or Socket
• Phillips head Screwdriver
• 5/16” Nut Driver or Flat Blade
Screwdriver
NOTES
Kit may not fit with the following
Aftermarket Parts Installed:
• Custom Hood
• Turbo Upgrade
• Please read the entire product guide before proceeding.
• Ensure all components listed on page 4 are present.
• If you are missing any of the components, call our customer
support.
• Do not work on your vehicle while engine is hot.
• Make sure the engine is turned off and the vehicle is in Park
or the Parking Brake is set.
4.
Loosen the clamp at the turbo inlet and
remove the bolt securing the resonator tube
to the shroud.
7.
Remove the air box by carefully pulling it
up out of the OE grommets. Be sure the
grommets remain in position for the S&B
installation.
2.
Disconnect the electrical connection for
the MAF sensor in the OE intake tube. Unclip
the wiring harness from the air box lid.
5.
Disconnect all rubber hoses and coolant
lines for the intake tube assembly and remove
the tube from the vehicle.
8.
Remove the air inlet gasket from OE air
box.
3.
Loosen the hose clamp at the intake tube
and unclip the 4 hinges on the air box lid.
Remove the lid assembly from the vehicle.
6.
Remove the bolt securing the air box to
the battery tray. Remove the OE filter from
the air box. The bolt will be reused with the
S&B air box.
9.
Install the air inlet gasket onto the Air Box
(A)
. Push the two prongs into the holes
located on the bottom of the Air box.
P/N: 75-5053 / 75-5053D
SEE EXPLODED VIEW ON PAGE 4
1
S&B FILTER MAINTENANCE
Cleanable
(KF-1050)
. If the enclosed filter is Red, it came pre-
oiled from the factory.
Disposable
(KF-1050D)
. If the enclosed filter is White, it is a
disposable filter and should be discarded once it reaches
capacity. This filter
(does not require oil)
.
BEFORE YOU START
CARB Status - Exempt
CARB EO #: D-590-9
Legal for use in CA or other states
adopting CA emissions standards
See Page 3 for more info.
Approx. Install Time 1Hrs 00Min
