Samyung SUPERTRACK SDA-390, Installation And Operation Manual

Page: 20 / 68

16
outputs or 16 outputs.
3. Operation
3.1. Front Panel Functions
1. MENU button – Press the MENU button for more than 3 seconds to enter the
set-up mode. When you want to escape from the set-up mode, press MENU again
for more than 3 seconds. Another function of the MENU button is that of checking
the error message when the SDA-390 makes an error. When the error LED is on,
press the MENU button briefly. Then, you will be able to see the hexadecimal error
message. Please press the NEXT button for about 2 seconds to clear the error. If
you press MENU briefly again, you can go back to normal operation.
NOTE: KA-80 ACU can display the error message as binary. Press the MENU
button and press NEXT button for 3 seconds. Then, you will be able to see the
binary error message.
NOTE: Operator can make sure the communication status of ACU and antenna as
below when press MENU and press SEARCH shortly again. Packet means the
number of command from ACU, loss means the number of loss on the PCU. The
more loss this display, communication status is not good.
Figure 3- 1 Packet Loss
2. SLEEP button – Press the SLEEP button to enter the sleep mode when antenna
is tracking the satellite. The antenna does not conical scan when the TRACK
button is pressed. It function can reduce the noise of motor when vessel is
anchored at the dock or calm shore. This button is also used to scroll left (
◀
) in
the menu.
3. NEXT button – Press the NEXT button to select your preprogrammed next
satellite. When your desired satellite is displayed, stop pressing NEXT, and then,
after 3 seconds, the antenna automatically searches for your desired satellite.