28
that polarity reference is not the equator. Therefore installer and user should check
whether there is polarity offset or not. If there is skew offset, skew angle should be
changed to get a higher signal.
Figure 3-16 Steps of TRIM function
d. Reset
Reset is selected when it delete the inputted skew angle. The skew angle on
desired satellite will be changed to initial skew angle after selecting the ‘RESET’
mode.
e. Save
Press ‘MENU’ after selecting the ‘SAVE’ mode, if you want to save the trim angle
is saved.
f. Exit
Press ‘EXIT’ to escape to upper menu.
Summary of Contents for SUPERTRACK SDA-390
