- - - -
I / O
S E T U P
- - - -
I N P U T
D A T A : I N T E R N A L
O U T
F O R M A T : N M E A - V 2 . 0
S A V E
W P / R U T
L O A D
W P / R U T
- - -
S A V E
W P / R U T
- - -
W P T
D A T A
0 0 1
R U T
D A T A
SAMYUNG ENC
setting menu. When SIMULATOR is working, left top side in LCD display shows "SIM" and flickering so
that it tells from normal working. This letter can be displayed in every screen mode. (except Menu screen).
1) Under the condition that letter of "SIMULATOR" is opposite by
, press
and select the one
among "off", "low", "mid", "high" by
and press
.
* Off in setting value is normal operation condition without using SIMULATOR and it is always set "off"
when the power is off. Low, mid, high is SIMULATOR speed.
6.12 I/O SETUP
In the item of I/O SET-UP, INPUT and OUTPUT related item can be set up and data of waypoints and
route can be put through PC.
After selection of I/O SETUP in main MENU screen, press
and the following screen is displayed.
1. INPUT DATA
This is for setting up whether GPS DATA can be used by either GPS. Receiver or other external system,
when it is setup with external system. "EXTERNAL" is displayed on the position of DATUM in the Main
Screen.
1) Way of setup
After letting "INPUT DATA". to be opposite by direction switch. press
, then the present set contents
will be displayed in opposite. After selection either "EXTERNAL" or "INTERNAL" by
, press
, then
set up is completed.
2. FORMAT
It sets up output methods when GPS data is put through EXTERNAL SYSTEM.
1) FORMAT SETUP
After "OUT FORMAT" is reversed by shift key. If press
, setup's contents is reversed. After selecting
changable table by
, if press
selected table do setup.
2) Setting modes are NMEA-V1.5, NMEA-V2.0, FURUNO CIF. Among them, can select one.
3. SAVE WP/RUT
If press
this items, show as left-picture.
1) After WPT DATA is reversed by
, if press
, stored WAYPOINTS DATA outputs to outside
device(PC). When output, output WAYPOINTS number shows left-display.
* When output, if pressing
immediately stop, return to WAYPOINTS, ROUTE.
* When output, if pressing
. immediately stop, return to WAYPOINTS, ROUTE.
<WAYPOINTS, ROUTE>
