Samwon ENG CNT-700, Manual, Page: 10 / 21

Batch Reset
Batch Set
0
Batch output
: key, key, key cannot use “ lock ”
5) Batch Setting Change
▶Push key one time during operate status mode.
First number will blinking and become batch counter setting mode.
▶ Change setting values use and key
▶ After change with wanted setting value, move to setting mode push by key.
** During the batch setting values is bigger than batch count values,
If change the batch setting values same or smaller than count values then batch output will be ON
If set the Batch setting values to) then the batch output will be maintain OFF status.
6) Batch Count Operation
1) Count
Batch Counting Values increase untill Batch reset input is initiated
If Batch count values reach to 999999 then go back to 0 like
’
s circulations
Batch Count Value ’ s dose not effected for key and external RESET input signal.
(1) Counter operation
If count values of the setting values of the 1layer model or 2
nd
layer setting values of the 2Layer model reach to batch
setting values then the Batch Output start ON.
(2) Timer operation
If count values of the setting Time values reach same with batch setting values then the Batch Output start ON.
* In case of output mode is
“
FLK
”
: if the Toff, Ton setting time is pass then the Batch count increase.
2) Batch Output
IF Batch output is start ON one time, the Batch will maintain ON status until the Batch Reset input.
RST
SET
UP PNT
BAN
T
UP PNT RST