Samsung VC-8916VN, Manual

Page: 17 / 19

EN-8 EN-9
FOR CLOTH FILTER BAG
After using,if the cloth filter bag is full of dust, clean the cloth filter bag and use it again.
NOTE :
Used dust bags can be sealed by removing
the film from the paper and sticking over the
suction opening.
REPLACING THE DUST BAG
2) Remove the dust bag from the cleaner
CYCLONIC FILTER(ONLY CYCLONIC FILTER TYPES)
1) To open the dust cover of the dust bag com-
partment, press the clamper upwards(the clam-
per is located at the front of the dust cover).
You can use a dust bag in your cleaner for a long time thanks to the Cyclonic Filter system and it
maintain the maximum cleaning efficiency.
The larger particle of dust filtered from Cyclonic Filter remain in Dust Barrel when suctioned air
and dust revolves in the Cyclonic Filter. So the dust bag contains only smaller ones.
When the Dust Barrel is filled with dust up to the indicating line, it needs disposing and cleaning.
Dust Barrel can be cleaned in water.
1. Turn the Dust Barrel to the left and pull it.
2. Disconnect the Cyclonic Filter from extension wand and handle.
3. Remove thread and hair tangled around the net.
4. After cleaning the Dust Barrel and Cyclonic Filter, connect the Cyclonic Filter with extension
wand and handle(washed part should be dried in the shade throughly before assembling.)
5. Push and turn the Dust Barrel to the right.
Adjust indicating marks each other carved on Dust Barrel and Cyclonic Filter.
4) Press the dust cover down gently until the
clamper relocks.
3) After removing the used dust bag, insert the
cardboard bag collar of the new dust bag into
its original position.
CYCLONIC
FILTER
DUST BARREL
CREVICE
TOOL
DUST-FULL INDICATOR
If the “Dust-Full” indicator switch changes to “RED” while you are cleaning, the dust bag is
full and must be replaced.
NOTE :
If the “Dust-Full” indicator continues to display “RED” even after changing the dust
bag, turn the cleaner off and check whether the hose, tube or nozzle is clogged.