CABle proteCtion
1.
As there may be direct leakage to the external cables when installed outside, please use waterproof butyl rubber tape to
protect the cables.
2.
Wrap the cable jacket (Area A) and the cable connectors with waterproof (butyl rubber) tape so that more than half of the
butyl rubber tape is tightly overlapped.
`
If the cable jacked in not wrapped properly, water will directly leak into the connectors.
`
Waterproofing butyl tape is made of butyl rubber which extends twice its normal length.
`
If the power cable terminal is not in use, wrap it with waterproofing tape.
instAllinG tHe CAMerA
The camera can be installed on the wall, ceiling, shelf or a desired position using the provided mounting bracket.
1.
Adhere the installation template onto the ceiling and use it as installation locating tool. (Please refer to Page 14 of Quick
Guide.)
2.
Choose an installation site that can sufficiently support the weight of the camera to be installed.
3.
Attach the camera bracket to the wall using the supplied screws.
4.
Adjust the direction of the camera to the desired direction, and tighten the bracket.
5.
Adjust the camera angle as needed.
6.
Connect the camera cable to the camera.
J
`
Take caution when installing the camera outdoors because the cable connectors may be wet with moisture or with dirt buildup.
`
Although the camera is IP66 rated, direct exposure to water or moisture may cause problem such as condensation.
English
_11
●
Get Close to
nvr
