Confidential
5G Indoor CPE Installation Manual
16
Copyright © 2018, All Rights Reserved.
On-site Inspection and Inspection Checklist
The on-site inspection is to perform inspection visually or using instruments for
each specification, standard, and installation status, and others based on the
inspection checklist actually at a site where the system is installed.
The inspector must record the results onto the inspection checklist during or after
filed inspection.
Sharing Inspection Results and Taking Corrective Actions
The inspector must share the inspection results (inspection checklist/corrective
actions) with an installation operator and, the installation operator must take the
corrective actions if necessary after reviewing the requirements.
Checking the Results of Corrective Actions
The inspector must check if the corrective actions are properly taken. If they are
not sufficient, the inspector must ask the installation operator to take the corrective
actions again
Sharing the Results of Corrective Actions and Preparing
Preventive Plan
After the corrective actions are all completed, the inspector must share the results
with the installation operator and relevant departments and prepare a preventive
plan to prevent the same or similar problems from re-occurring.
Construction Situation Checklist
Table 5. Construction Situation Checklist
Category
Check Items
Criteria
Result
Pass
Fail
Installing
Equipment
Appearance of equipment
and mechanical parts
Equipment damage such as Dent,
scratch and crack, and so on.
Placement of equipment
and mechanical parts
Maintenance and horizontal/vertical
placement
Leveling condition of
equipment and
mechanical parts
Horizontal/vertical status
Validity of status and
specifications of tightening
bolt/nut/washer, others.
Checking fasteners omission
Compliance with assembly order of
fasteners
Compliance with tightening torque
value
Insulation status
Checking electrical contact between
insulators (insulation resistance tester)
