Confidential
5G Indoor CPE Installation Manual
9
Copyright © 2018, All Rights Reserved.
Indoor CPE Installation
This section describes the procedures to fix the indoor CPE on a window sill.
There are other mounting methods that may be available for installation. However,
the main objective is that the unit shall be firmly mounted.
The Indoor CPE bottom shows the proper orientation of the CPE side facing
outside the window. Make sure to check the correct orientation while installing.
The Indoor CPE must be fixed vertically as depicted in the following guidelines.
Fixing CPE on Window Sill
For the installation directions and fixing method, see the following images.
The indoor CPE installation on a window sill is a convenient and quick method to
install the CPE with good RSRP measurement conducted as a pre-qualification
with Spectrum analyzer.
To install the CPE on a window sill:
1
Locate the CPE fixing point on the window sill and make sure the surface is
free of dust and debris.
2
Unwrap and attach the 3M dual lock on the base of the window sill and to the
bottom part of the CPE as depicted in the figures below.
3
Make sure to check the direction mark at the bottom of the CPE stand as
shown in the figure below.
4
Make sure the CPE is firmly positioned on the window sill with 3M dual lock.
