Samsung SF-5800P, User'S Manual Setup And Operation

Page: 73 / 99

2 .40
Other Functions
¥ RX REDUCTION ÑWhen receiving a document as long as or longer than
the paper installed in your machine, the machine can reduce the data in
the document to fit into your recording paper size.
Turn on this feature if you want to reduce an incoming page that may
otherwise need to be divided into two pages with only a few centimeters
on the second page. If the fax machine cannot reduce the data to fit into
one page with the feature enabled, the data is divided and printed in
actual size on two or more sheets if needed.
Press 1 to turn this feature on. Note that this feature does not apply to the
copy mode.
Press
2
to turn this feature off. The overflow data will be printed out on a
second page.
Original Received data
Original Received data
- H.(Horizontal) REDUCTION ÑIf you turn the RX reduction feature on,
you are allowed to set the horizontal reduction feature on or off. When
you set the horizontal reduction to be off, the machine will reduce an
incoming page containing overflow data only in vertical as shown below.
If you want to reduce both in vertical and horizontal at the same rate in
order to maintain height to width relationships, turn the horizontal
reduction feature on. If you turn on this feature, the machine reduces the
data as shown below.
Press 1 to turn this feature on.
Press 2 to turn this feature off.
¥ DISCARD SIZE ÑWhen receiving or copying a document as long as or
longer than the paper installed in your fax machine, you can set the fax
machine to discard any excess image at the bottom of the page to fit into
the recording paper size.
If the received page is outside the margin you set, it will be printed on
two sheets of paper at the actual size.
If the data is within the margin, and the Auto Reduction feature is turned
on, it will be reduced to fit into the appropriate size paper (Discard does
not take place). If the Auto Reduction feature is turned OFF or fails, the
data within the margin will be discarded.
Enter the desired discard size using the number keypad, and press Enter .