_05
ENG
camera assembly & mount
1.
Dome Base Mounting
- Remove the protecting sheet from the rubber bottom and attach it on the base housing.
- Fix the base housing with the supplied 4pcs of screws(No. 8-32 UNC) on the ceiling or wall.
2.
Power Supply & Monitor Impedance
(Power supply)
- Adaptor: AC24V / 600mA or DC12V / 800mA (AC24V / DC12V Model)
(Monitor Impedance, if available)
- Set the impedance switch to the 75 standard position unless a video equipment is connected
to the monitor video out.
3.
Camera Module Adjustment
(Pan&Tilt Adjustment)
- Adjust the camera direction by turning the pan bracket left or right, the tilt bracket up or down,
then fix the screws tight.
(View Angle Adjustment)
- For a wider view angle move the zoom lever to wide, for a narrower view angle move it to tele.
- After accurate adjustment of focal length then adjust the focus lever to near or far for the
sharpest focus.
4. Decoration Ring Mounting
- Firmly fix the decoration ring into place with the screws and by using the supplied L-wrench on
the base housing.
camera assembly & mount
01-SCC_B9374_NA-ENG.indd 5
2008-01-28 오후 2:27:57
