Mobile WiMAX/TD-LTE RRH-2WB Installation Manual/Ver.2.0
© SAMSUNG Electronics Co., Ltd.
C-11
C.4.2 When Connecting a Connector to another Connector
Below is the procedure for shrinking the heat shrink tube.
Figure C.10 Shrinking the Heat Shrink Tube_Connection between Connectors (1)
1) Prepare a 1/2 in. feeder line, 7/8 in. feeder line,
heat shrink tube, and heating gun to finish the
cable using a heat shrink tube.
3) Insert the heat shrink tube, placing connector part
(where 1/2 in. and 7/8 in. feeder line will be connected)
in the center, and mark the center part.
Heat Shrink Tube (Jelly Type)
38/12 × 300 mm (11.81 in.)
7/8 in. Feeder Line
Connector
1/2 in. Feeder Line
Heating Gun
2) Inset the heat shrink tube to one end of the feeder
line and connect the connector.
Summary of Contents for RRH-2WB
Page 1: ...Ver 2600 00ETB9GAA 2 0 Mobile WiMAX TD LTE RRH 2WB Installation Manual ...
Page 6: ...INTRODUCTION IV SAMSUNG Electronics Co Ltd This page is intentionally left blank ...
Page 12: ...SAFETY CONCERNS X SAMSUNG Electronics Co Ltd This page is intentionally left blank ...
Page 138: ...ANNEX F Standard Torque F 2 SAMSUNG Electronics Co Ltd This page is intentionally left blank ...