Samsung RRH-2WB, Installation Manual

Page: 114 / 141

ANNEX C. Connector Assembly
C-6 © SAMSUNG Electronics Co., Ltd.
C.2 Din type-male (1/2 in. Feeder Line)
Below is the method for assembling the Din type-male connector to the 1/2 in. feeder line.
Figure C.5 Assembling the Din type-male (1/2 in. Feeder Line) Connector (1)
2) Straighten the cable, then, using a suitable tool, strip it to the connector’s wire strip length.
When cutting the sheath, hold the cable firmly with one hand and cut the cable pulling the cutting
tool inwards with the other hand. Gently rotate the tool several times (do not pull it too hard), so that
the internal copper line is not damaged.
3) Using a cutter, cut the sheath from the stripped edge to the end of the cable and completely strip the sheath.
Cutting Tool
Cutter
Feeder Line
1) The components of the Din type-male are an Din type-male body, pin, an insert ring, a clamping nut,
o-ring, and a heat shrink tube, and it is assembled using the wire stripper, trimming tool, wrench, etc.
4) Insert the o-ring, clamping nut, insert ring, pin and Din type-male body into the stripped feeder line in
this order.
Din type-male Body
Pin
Insert Ring
Clamping Nut
O-Ring
Feeder Line
Heat Shrink Tube