ENGLISH-
33
troubleshooting
Symptom
checklist
the PoWeRbot is not
working at all.
f
Check if the emergency switch is on.
f
Check if all the icons are displayed on display panel.
f
Check if the battery of POWERbot is depleted.
–
When "Lo" is displayed, carry POWERbot to the docking station to charge it.
f
Replace the batteries (AAA type) when the remote controller is not working.
the PoWeRbot
is stopped during
cleaning process.
f
When "Lo" is displayed on the display panel, carry POWERbot to the docking
station to charge it.
f
When POWERbot is stuck by the obstacles such as cord, threshold etc, pick it
up to remove it from the obstacle.
–
If any fabrics or strings are caught in the drive wheel, turn off the emergency
switch and remove the fabrics or strings before using it again.
Suction power is weak.
f
If the "Filter inspection indicator" is on, turn off the emergency switch and clean
the dustbin.
f
When there's too much dust in the dustbin, suction power may get weakened.
Turn off the emergency switch and empty the dustbin.
f
If the intake (on bottom of POWERbot) is blocked by foreign matters, turn off
the emergency switch and remove foreign matter from the intake.
f
When noise suddenly increase, turn off the emergency switch and empty the
dustbin.
the PoWeRbot cannot
find the docking
station.
f
Check if there's power failure or whether the power plug is unplugged.
f
Remove any obstacles around the docking station that may disturb POWERbot
from returning to the docking station.
f
When there's foreign matters on the charge pins that affects charging, clean
the foreign matter.
the PoWeRbot passes
through the Virtual
guard.
f
If the batteries are depleted, replace them. (2 type D (LR20) batteries)
f
If the lamp is off, check if the Virtual guard is turned off and turn it on.
the PoWeRbot
suddenly cleans
diagonally.
f
Check if the docking station is installed along the grain of wooden floors or
tiles.
f
It may clean in diagonal direction for moving to another area in shortest route,
or it made contact with any obstacles in that angle, or if it was charged at the
charged at an angle, or grain of the wooden/tile floor is in that direction.
Point cleaning is not
working.
f
If you point the red light directly on POWERbot, it may not move to desired
direction.
–
Point the red light on the floor within 39 in (1 m) around POWERbot.
✻
✻
Do not use the point cleaning under direct sunlight, bright light or on dark
floors.
"Filter inspection
indicator" is on even
after the dustbin has
been emptied.
f
Use POWERbot after turning off the emergency switch and then turning it back
on.
f
Empty the dustbin again and re-clean the filter thoroughly.
SR9300K_EN_DJ68-00743E-00_EU.indd 33
2016-02-03 오후 8:24:08
