12_
installing the dishwasher
installing the dishwasher
Plumbing
1.
Check the hot water connection on the back left-side of the base of the dishwasher.
The mounting plate should be secured to the back of the base, the threads inside the
connection should be smooth and shiny, and the area should be clean and free of any
debris.
2.
Make sure the dishwasher and the accessories are all included in the package to ensure
these assemblies are not cracked and that all connections are secure.
3.
Check the drain hose for any holes or deformities that could allow a water leak during
draining.
Electrical
1.
Confi rm the junction box cover is secured to the junction box on the front right-side of the
base of the dishwasher.
2.
Confi rm the electrical box was not damaged during shipping and that it is secured to the
base of the dishwasher.
Appearance
1.
Confi rm there are no dents or scratches on the front of the dishwasher.
2.
Check the edges of the doors for any roughness or cracking
3.
Check the control panel to ensure it is clear and unscratched, and that all the control markers
are in their proper places.
Parts
1.
Confi rm you have all the parts listed in Step 1 on page 6.
STEP 6
PREPARING THE DISHWASHER
1.
Attach the protective sticker (A).
- To prevent damage, put the protective sticker on the bottom of the counter top as
shown in the picture.
Before putting the protective sticker, clean the counter top as shown in the picture.
For information, the length of the protective sticker is 26 inches (660 mm).
A
A
2.
Ensure that the circuit breaker and water supply valve are turned off before proceeding with
the following steps.
Before you move or lay down the dishwasher for installation, make sure to adjust the height
of the legs so the legs are as short as possible. This prevents the legs from breaking.
Level the dishwasher by adjusting the height of the legs after you have the dishwasher in
place.
CAUTION
DW9900M-00183A-01_EN.indd Sec3:12
DW9900M-00183A-01_EN.indd Sec3:12
1/2/2017 12:41:08 PM
1/2/2017 12:41:08 PM
