Alignment and Adjustments
6-3
Samsung Electronics
6-1-2 Head Switching Point Adjustment
1) Playback the alignment tape.
2)
Short the “TEST” Point on VCR MAIN PCB to set the adjustment mode.
. (See Fig. 6-2)
3) Press the “1, 0” buttons; remote control adjustment operates automatically. (See Fig. 6-1)
6-1-3 NVRAM Option Setting
1)
Short the “TEST” Point on VCR MAIN PCB to set the adjustment mode.
. (See Fig. 6-2)
2) Press the “1, 4” button on the remote control. The option setting appears. (See Fig. 6-3)
3) Select the option number (See table 6-1) of corresponding model with “ ,
, , ” buttons on the
remote control.
4) After selecting the option number is completed, press the “ ” button of remote control.
(If “ ” button is pressed, the selected number is changescolor. ; See Fig. 6-4)
5) Press the “ENTER” button of remote control again to store the option number.
6) Turn the Power off.
1) NVRAM Option is adjusted in the factory.
2) In case Main PCB Micom (IC601) and NVRAM (IC603 ; EEPROM) are replaced, be sure to set the corresponding option number of the
required model. (If the option is not set, the unit will not operate.)
MOVE : SAVE : ENTER
01
02 03
04
05
06
07
08
09 10 11 12 13 14 15 16
17 18 19
20
21
22 23 24
25 26 27 28 29 30 31 32
33 34 35 36 37 38 39 40
Fig. 6-3
MOVE : COMPLETE
01
02 03
04
05
06
07
08
09 10 11 12 13 14 15 16
17 18 19
20
21
22 23 24
25 26 27 28 29 30 31 32
33 34 35 36 37 38 39 40
Fig. 6-4
