ENG-9
Plug & Auto Set up
Tuning Your Television for the
DVD-VCR
You must tune your television for the DVD-VCR only if
you are not using a RCA cable
➢
To view pictures from your DVD-VCR when a
RCA cable is used, the television must be set to
the audio/video mode (AV).
1
Switch on the television.
2
Switch on the DVD-VCR by pressing
STANDBY/ON on the front of the DVD-VCR or
STANDBY/ON on the remote control.
3
Select a programme position on the television to be
reserved for use with your DVD-VCR.
4
Insert the video cassette in the DVD-VCR. Check
that the DVD-VCR starts reading the cassette; if
not, press
❿
II
button.
5
Start a scan on your television or set the television
to UHF channel 36 (Australia:UHF 38 CH).
6
Fine tune the television until the pictures and sound
are obtained clearly.
Auto setup
Please wait
00 %
Clock Set
12 : 00 1/JAN 2004 THU
Time Date Year
➢
Auto preset can be performed by pressing
■
on
the VCR continuously for 5 seconds or more
with no tape inserted.
Deck Control Keys
The DVD-VCR uses one set of controls to operate both
decks. The following keys are helpful in successfully
controlling each deck.
1
Standby/on Button
Press the STANDBY/ON button on the remote
control or front panel to turn on the DVD-VCR.
2
DVD Button
Press the DVD button on the remote control when
you want to control the DVD deck.
◆
The DVD indicator will light on the Front Panel
Display to show that the DVD deck is selected.
3
VCR Button
Press the VCR button on remote control when you
want to control the VCR deck.
◆
The VCR indicator will light on the Front Panel
Display to show that VHS deck is selected.
4
INPUT SEL. BUTTON
Press the INPUT SEL. button repeatedly to cycle
through all of your input sources, including the
Tuner (PR##), Line 1 (rear AV input), and Line 2
(front AV input).
• Input select is only available when the VCR deck
is selected.
➢
Before using the VCR operation of 10~28 pages,
press the VCR button on the remote control to
select VCR mode.
Before using the DVD operation of 29~45
pages, press the DVD button on the remote
control to select and watch DVD.
7
If you cannot find the pictures and sound, or there
is interference from nearby channels, it may be
necessary to change the setting of the DVD-VCR
output channel (see Setting the DVD-VCR Output
Channel on page 14 and Problems and Solutions
on page 47).
8
When the picture and sound are perfectly clear,
store this channel at the desired programme
position on the television.
Result: That programme is now reserved for use
with your DVD-VCR.
