ENG-14
You can choose the sound mode (B/G or D/K)
according to the TV set connected to your VCR.
1
After pressing the MENU, press the OK or
❿
.
Result: The Setup menu is displayed.
2
Press the corresponding
,
❷
buttons to select
the Install option.
3
Press the OK button to select this option.
Result: The Install menu is displayed.
4
Press the OK or
❿
buttons, until the TV System
option is selected.
5
Press the OK or
❿
button to select G or K.
6
On completion, press RETURN to exit the menu.
Your DVD-VCR output channel may need to be
changed if the pictures suffer from interference or if
your TV cannot find the pictures.
Also, you can change the DVD-VCR output channel to
adjust the frequency in which information is displayed
on the screen.
1
After pressing the MENU, press the OK or
❿
.
Result: The Setup menu is displayed.
2
Press the corresponding
,
❷
buttons to select
the Install option.
3
Press the OK or
❿
to select this option.
Result: The Install menu is displayed.
4
Press the
,
❷
buttons, until the VCR Output CH
option is selected.
5
Select the required output channel (CH21 ~ CH69)
by pressing the OK or
❿
buttons, and
➛
buttons.
(Australia:CH28 ~ CH69).
(Australia Model)
➝
CH28
↔
.. CH38
↔
.. CH69
(Newzealand Model)
➝
CH21
↔
.. CH36
↔
.. CH69
6
On completion, press RETURN to exit the menu.
Then tune your television again (see page 9).
Setting the DVD-VCR Output
Channel
Selecting the RF OUT Sound Mode
(B/G-D/K)
(Newzealand Model only)
Auto Setup
Manual Setup
Install
TV System : G
VCR Output CH : CH 36
G
K
Auto Setup
Manual Setup
VCR Output CH : CH 38
Install
Auto Setup
Manual Setup
TV System : G
VCR Output CH : CH 36
Install
Australia Model
Newzealand Model
CH:28
:
CH:38
:
CH:69
CH:21
:
CH:36
:
CH:69
6
Press the corresponding
,
❷
buttons, until the
required preset TV programme is selected.
Result: The selected station is displayed at the
same time on the television screen.
7
To change the programme number assigned to a
station press the OK button on the remote control.
(For example, To move a TV station in programme
1 to programme 3)
8
Press the
,
❷
buttons to select required position.
And then press OK again to swap the position.
9
On completion, press the RETURN button four
times to exit the menu.
➝
➝
