22
- English
C
onnecting & Setting Up
If your TV has a HDMI/DVI input, connect HDMI/DVI
cable to a TV. You will enjoy the best quality images
and sounds.
●
Case 1 : Connecting to a TV with HDMI Jack
●
Case2 : Connecting to a TV with DVI Jack
Case 1 : Connecting to a TV
with HDMI Jack
• Using the HDMI cable connect the HDMI OUT
jack on the rear of the DVD Recorder to the HDMI IN
jack of your TV.
• Press the input selector on your TV remote control
until the HDMI signal from the DVD Recorder appears
on your TV screen.
Case 2 : Connecting to a TV
with DVI Jack
• Using the DVI Adapter Cable, connect the HDMI OUT
jack on the rear of the DVD Recorder to the DVI IN
jack of your TV.
• Using the audio cables, connect the AUDIO (red and
white) OUT jacks on the rear of the DVD Recorder to
the AUDIO (red and white) IN jacks of your TV. Turn
on the DVD recorder and TV.
• Press the input selector on your TV remote control
until the DVI signal from the DVD Recorder appears
on your TV screen.
Connecting HDMI/DVI to a
TV
■
To watch through the HDMI output, set
the digital audio output to PCM.
See page 33~34.
■
Depending on the HDMI device (TV/HDMI
Receiver) you use, audio may not be
supported. If TV does not support Dolby
digital/DTS, Audio output is not available
when you set Digital output as Bitstream
or select DTS On in Audio setup menu.
In this case, set the digital audio output to
PCM or DTS off.
CAUTION
To change HDMI output resolution, see
page 37.
HDMI (High Definition Multimedia
Interface)
HDMI is an interface to enable the digital
transmission of video and audio data with
just a single connector. Since HDMI is
based on DVI, it is completely compatible
with DVI. The only difference between
HDMI and DVI is that HDMI supports
multi-channel audio.
Using HDMI, the DVD recorder transmits
a digital video and audio signal and
displays a vivid picture on a TV having an
HDMI input jack.
HDMI connection description
HDMI connector - Both uncompressed
video data and digital audio data (LPCM
or Bit Stream data).
- Though the DVD recorder uses a HDMI
cable, the DVD recorder outputs only a
pure digital signal to the TV.
- If TV does not support HDCP (High-
bandwidth Digital Content Protection),
snow noise appears on the screen.
Why does Samsung use HDMI?
Analog TVs require an analog video/audio
signal. However, when playing a DVD, the
data transmitted to a TV is digital.
Therefore either a digital-to-analog
converter (in the DVD Recorder) or an
analog-to-digital converter (in the TV) is
required. During this conversion, the
picture quality is degraded due to noise
and signal loss. HDMI technology is
superior because it requires no D/A
conversion and is a pure digital signal
from the DVD recorder to your TV.
What is the HDCP?
HDCP (High-bandwidth Digital Content
Protection) is a system for protecting DVD
content outputted via HDMI from being
copied. It provides a secure digital link
between a video source (PC, DVD. etc)
and a display device (TV, projector. etc).
Content is encrypted at the source device
to prevent unauthorized copies from being
made.
NOTE
white
red
white
red
00842M-R125-XEH_18~41 2005.6.29 6:35 AM Page 22
