Samsung DMR57 Series, Service Manual

Page: 27 / 106

3-13
3. Disassembly and Reassembly
Part Photo Description
Panel Control
(DMR57 series)
1. Open the door completely.
Remove the twelve (12) screws holding the tub front,
fame front, and panel front in place.
Caution
Before removing the screws, place a cushioned mat
on the floor to prevent the handle and frame front
from being scratched. After removing them, make
sure to hold the tub front with your hand while you
are working as the tub may close and harm you.
Caution
Do not place the removed screws on the tub front.
They may fall into the sump assy.
2. Remove the fan motor connector.
3. Now remove the frame front and the panel control
assy. Place it on the floor and perform the following:
Remove the panel control from the frame front.
You can remove the panel control by holding and
pulling it.
And, you can remove and replace the door lock
switch in this step. (Remove both connectors of door
lock switch.)
4. Remove the two (2) screws holding the panel control
and the display LED in place. Remove the two (2)
display LED connectors.
Now, you can remov e the seal guide LED and the
display LED.