6
Deciding to where to install the outdoor unit
Decide the installation location based on the following condition and obtain the user’s approval.
X
Avoid a place that may disturb your neighbor. Noise may occur from the outdoor unit and the discharged air may run into
the neighborhood. (Be careful of the operation time in a residential area)
X
Install the outdoor unit on a hard and even area that can support its weight.
X
Choose a flat place where rainwater does not settle or leak.
X
Choose a place that will avoid strong winds.
X
Choose a place that is well ventilated and allows enough space for repairs and service.
(Discharge duct can be purchased privately.)
X
Choose a place where the connection of refrigerant pipe between an indoor unit and outdoor unit is within allowed
distance.
X
Make sure that the condensed water dripping from the drain hose runs out properly and safely.
X
Choose a place where flammable gas does not leak.
X
Choose a place where the unit could not come into contact with snow and rain.
X
When installing the outdoor unit near sea shore, make sure it is not directly exposed to sea breeze.
- When installing the outdoor unit near sea shore, consult the qualified installer since the places above require additional
measures for corrosion resistance. (You should remove salt and dust of a heat exchanger at least once a year.)
Installation Guide at the seashore
Make sure to follow below guides when installing at the seashore.
1) Do not install the product in a place where it is directly exposed to sea water and sea breeze.
- Make sure to install the product behind a structure (such as building) that can block see breeze.
- Even when it is inevitable to install the product in seashore, make sure that product is not directly exposed to sea breeze
by installing a protection wall.
2) Consider that the salinity particles clinging to the external panels should be sufficiently washed out.
3) Because the residual water at the bottom of the outdoor unit significantly promotes corrosion,
make sure that the slope does not disturb drainage.
- Keep the floor level so that rain does not accumulate.
- Be careful not to block the drain hole due to foreign substance
4) When product is installed in seashore, periodically clean it with water to remove attached salinity.
5) Make sure to install the product in a place that provides smooth water drainage. Especially, ensure that the base part has
good drainage.
6) If the product is damaged during the installation or maintenance, make sure to repair it.
7) Check the condition of the product periodically.
- Check the installation site every 3 months and perform anti-corrosion treatment such as R-Pro supplied by SAMSUNG
(Code : MOK-220SA) or commercial water repellent grease and wax, etc., based on the product condition.
- When the product is to be shut down for a long period of time, such as off-peak hours, take appropriate measures like
covering the product.
ki]_TW__]_hTWXptk}tGzGljvG䖐㨴㥐㛨ὤhhluUGGG]
YWYWTWZTY^GGG㝘䟸GYaX[aY]
