Samsung ACH1800E, Service Manual

Page: 62 / 150

Samsung Electronics
Installation
4-43
6. Connect the power cables.
Note : Cable Specifications
7. Reassemble the centralized controller.
4-2-19 Receiver & Display Unit Installation
(Optional)
Accessories
In case of using the wireless remote controller, you must
install the receiver & display unit to the front panel
before fixng the panel.
1. Disassemble three screws on the place where
you would like to install the receiver & display
unit, inside the front panel.
2. Remove the part of the front panel.
3. Secure the receiver & display unit with the
screws.
4. Connect the end of the connector wire to the
receiver & display unit and connect the other
end of the wire to the electrical component box
as shown in figure.
Caution :
•The optional kits must be installed by an installation
specialist.
•Before installing the optional kits, ensure that you have
turned off the main power.
•All optional kits cables should be installed according to
the national wiring rules and you must install them in the
wall not to be touched by users.
Caution :
•Do NOT keep the wired remote controller cables with a
220V cable because the remote controller cables have
low voltage.
Caution :
•Optional kits must be installed by an air conditioner specialist.
•Before installing the optional kits, ensure that you have turned
off the main power.
Size of cables 0.75mm 2 ~1.25mm 2
Cable type
Double-insulation,
2G
220V-240V~, 50Hz
Power Supply
Receiver
& Display
Unit
Wireless Remote
Controller(1)
KR-H40200
Receiver &
Display Unit(1)
(KRE-H1000)
Battery(2) M4 X 16 Tapped
Screw(2)
Remote Controller
Holder(1)
00152-OIAIN-5 2/1/01 1:57 PM Page 4-43