11
AA
ENGLISH
t .BLFTVSFUIFJOEPPSVOJUJTJOVQSJHIUQPTJUJPOXIFOZPVQPVSXBUFSUPDIFDLGPSMFBLBHF
.BLFTVSFUIBUUIFXBUFSEPFTOPUPWFSøPXPOUPUIFFMFDUSJDBMQBSU
Change the direction only when it is necessary.
1. Detach the rubber cap with the plier.
2. Detach the drain hose by pulling it and turning to the left.
3. Insert the drain hose by fixing it with the screw into the groove of the drain
hose and the outlet of the drain pan.
4. Attach the rubber cap with a screwdriver by turning it to the right until it
fixes to the end of the groove.
5. Check for leakage on both side of the drain outlet.
Changing direction of the drain hose
Drain hose
Screw hole
Screw
3VCCFSDBQ
Drain pan outlet
Pour the water in direction of arrow.
Ê
Direction of the drained water
Fixing the indoor unit in place
Insulation
Pipes
Perform the following work on the area where gas leak test was done priorly.
"GUFSDIFDLJOHGPSHBTMFBLTJOUIFTZTUFNJOTVMBUFUIFQJQFIPTFBOEDBCMFT
Then place the indoor unit on the installation plate.
1. To avoid condensation problems, wrap foam insulation (as shown in the figure) on a
part without insulation on the end of the pipes.
2. Wind the pipe, assembly cable and drain hose with vinyl tape.
3. Place the bundle (the pipe, assembly cable and drain hose) in the lower part of
the indoor unit carefully so it does not project from the rear of the indoor unit.
4. Hook the indoor unit to the installation plate and move the unit to the right and
left until it is securely in place.
5. Wrap the rest of the pipe with vinyl tape.
6. Attach the pipe to the wall using clamps (optional).
Installation
plate
Connecting wires
Connecting
pipes
7JOZMUBQF
Drain hose
t .BLFTVSFQJQFEPFTOPUNPWFXIFOZPVJOTUBMMUIFJOEPPSVOJUPO
an installation plate.
Summary of Contents for AC444FBRDEH
Page 1: ......
Page 21: ...21 ENGLISH Memo ...
Page 22: ... EEE Yönetmeliğine Uygundur This EEE is compliant with RoHS ...