Samson 6132, Mounting And Operating Instructions

Page: 21 / 44

EB 6132 EN 6-1
Start-up
6 Start-up
The work described in this section is only to
be performed by personnel appropriately
qualified to carry out such tasks.
Risk of fatal injury due to electric shock
(devices with 230 V supply voltage).
Î
Before connecting wiring, performing
any work on the device or opening the
device, disconnect the supply voltage
and protect it against unintentional re-
connection.
Î
Only use power interruption devices that
are protected against unintentional re-
connection of the power supply.
Start-up conditions
Before start-up, make sure the following con-
ditions are met:
− The converter is properly mounted ac-
cording to the instructions.
− The pneumatic and electrical connections
have been properly performed according
to the instructions.
− The prevailing conditions in the convert-
er's environment meet the converter's
technical specifications. See specifica -
tions on on the nameplate ('Markings on
the device' section) and in the technical
data ('Design and principle of operation'
section).
Putting the converter into operation
Î
Switch on supply voltage.
See the 'Markings on the device' section
for permissible voltage according to
specification on the nameplate.
The converter is tested by SAMSON and the
output signal is adjusted to the required
range. In case of inconsistencies caused by
the converter despite it being mounted cor-
rectly, the zero and span can be retuned
(see the 'Servicing' section).
DANGER !
Note !