JOLLY
www.larius.com
15
REV.
01 - 09/2020 - Cod. 150165
Follow the washing procedure before using again
the equipment.
Before performing any maintenance operation,
discharge the pressure in the pumping unit
(open
the drain valve
).
ALWAYS DISCONNECT THE POWER SUPPLY
AND RELEASE THE PRESSURE IN THE PUMPING
GROUP
(open the drain valve)
BEFORE TIGHTE-
NING THE PACKING NUT.
•
Lift again the suction pipe and remove the solvent tank.
•
Now point the gun into the solvent tank and press the trigger
so as to recover the residual solvent.
•
As the pump starts idling, press the switch OFF
(0)
to
stop the equipment.
•
In case of long storage, we recommend you to suck and
to leave light mineral oil inside the pumping group and the
flexible hose
.
DAILY
• Clean the filters;
• Clean the nozzles;
• Clean the painting circuit with a suitable product.
PERIODICALLY
• Check the pumping gaskets tightening
(if the product draws,
replace the gaskets)
;
• Clean the mobile parts from the varnish deposits
(spray guns,
etc.)
;
• Check that the tubes and all the fittings are correctly tightened.
GENERAL MAINTENANCE
K
CHECK ON THE PACKING NUT
Daily check the packing nut is tight in order to avoid wastes but
not excessively to prevent the piston from seizing and the
gaskets from wearing
.
•
For tightening, use the wrench supplied
(ref. 11503)
.
Rif. 11503
Adjusting
wrench
Oil ring
ROUTINE MAINTENANCE
L
•
Use the lubricant supplied
(ref. 16340)
to allow an easy sliding
of the piston inside the gasket group.
Daily top up the packing nut.
OIL
Rif. 16340
J4
J5
Fig. 3J
Fig. 1L
Fig. 2L
