Samlex Europe WSC-1250Li, Manual, Page: 33 / 39

33
ENG
12 Use the Charger
Table 12-1 Normal Functional Check Table
"E.Q." LED (not in Lithium mode) "STATUS" LED Status
Red, constantly lit I/CC phase
Orange, constantly lit Uo/CV phase
Green, constantly lit U/battery full phase
Red, constantly lit Red, constantly lit I phase, Equalization
is activated
Red, constantly lit Orange, constantly lit Uo phase, Equalization
is activated
Red, constantly lit Green, constantly lit U phase, Equalization
is activated
Red, constantly lit Equalization is executed
Red, flashing I/CC phase, half power
Orange, flashing Uo/CV phase, half power
Green, flashing U/battery full phase, half power
Green, double flashing Power supply mode (not in
Lithium mode)
Red, slowly flashing Stand-by mode
(RC-600/RC-601D)
13 Trouble Shootings
13.1 The battery voltage would NOT increase after charging
• If possible, measure with a suitable multi-meter during the charging to verify if the voltage
at the battery terminals increases.
• Determine whether the terminals are connected properly to the battery poles. Clean the
battery poles if necessary to ensure better connection.
13.2 The battery is NOT fully charged after a charging time about 20 hours
• Disconnect the power to the charger.
• Remove the battery from the charging terminals and wait for a few minutes.
Then, measure the voltage at the battery terminals with the multi-meter.