30
ENG
11
Using the Charger Lithium
11.1.3 CV phase (Constant Voltage)
The "STATUS" LED constantly lights Orange.
This main charging phase could be set to the maximum of 1 minute, 1 hour, 2 hours or
4 hours. Switching to the next phase also depends on the current 5% or 10% of the set
charging power.
Note
The charging voltage, current and time for the CV phase can be selected by means of the switch field S1.
11.1.4 Battery full phase
The "STATUS" LED constantly lights Green. If the current decreases to 10% or under the
rated current or if the time limit of 1 minute, 1 hour, 2 hours or 4 hours is exceeded, then
the charger switches over to the battery full phase. When using the first 3 positions of SW1
and 2 (see chapter 9.1, page 22) the charger stops and does not return to the CC phase until
the voltage drops below the 12.5V/25V. In position 4 the charger goes to float and delivers
13.8V/27.6V. If the voltage drops below 12.5V/25V, the charger returns to the CC phase.
Note
Batteries may be charged separately from the three-fold charging connections. The outputs are
separated internally by FET's, thus the weaker battery will be always first charged to the charging level
of the stronger battery.
Attention
The maximum battery capacity should NOT exceed the specified capacity, otherwise the
functions of the individual charging phases could be influenced.
11.1.5 Equalization
The Equalization is not possible in the Lithium mode.
11.2 Using the remote controller RC-600
There are three buttons and four LEDs on RC-600 (see Figure 10 Remote Controller RC-600,
Page. 7).
• ON/OFF button to switch the charger ON and OFF
• Half Power button to enter/exit "HALF POWER" mode
• Equalization button to activate the function of equalization (does not function in
Lithium mode)
• Bulk LED to indicate the charging stage of CC phase
• Absorption LED to indicate the charging stage of CV phase
• Floating LED to indicate the charging stage of Battery full phase
• Equalization LED to indicate the function of equalization is activated (does not function
in Lithium mode)
Summary of Contents for WSC-1250Li
