Samlex Europe WSC-1250Li, Manual, Page: 26 / 39

26
ENG
10 Using the Charger Gel/AGM/Lead-acid
10.2 Using the remote controller RC-600
There are three buttons and four LEDs on RC-600 (see Figure 10 Remote Controller RC-600,
Page. 7).
• ON/OFF button to switch the charger ON and OFF
• Half Power button to enter/exit "HALF POWER" mode
• Equalization button to activate the function of equalization
• Bulk LED to indicate the charging stage of I phase
• Absorption LED to indicate the charging stage of Uo phase
• Floating LED to indicate the charging stage of U phase
• Equalization LED to indicate the function of equalization is activated
To avoid the VOID setting from the remote control, please refer to Table 10-1 VOID Setting.
Table 10-1 VOID Setting table for pressing button on remote controller
RC-600 buttons
Charger working mode
Half power Equalization Others Power Supply
"HALF POWER"
pressed
Exit "HALF
POWER"
("STATUS" LED
lights)
VOID
Enter "HALF
POWER"
("STATUS" LED
flashing)
VOID
S3 "E.Q." pushed
VOID VOID
Equalization
("E.Q." LED
lights Red)
VOID
"ON/OFF" pressed
Stand by
("STATUS" LED
slowly flashing
Red)
Stand by
("STATUS" LED
slowly flashing
Red)
Stand by
("STATUS" LED
slowly flashing
Red)
Stand by
("STATUS" LED
slowly flashing
Red)
Note
• The power switch at the unit must be switched ON, so that the unit can be switched ON and OFF
with the remote control.
• The "ON/OFF" button on the RC-600 should be pressed for 2 seconds to switch OFF the battery
charger, and 0.5 second to turn ON.