Samcon ExCam Series, Installation Manual

Page: 17 / 24

Doc.-ID: 180731-PT08BAU-SS-Ex Installation Manual rev.00.docx, Page 17 of 24
- Caution: Do not touch the screw threads with your skin or clothes! There is oil lu-
bricating paste to protect the surface against fretting corrosion and mechanical
stresses.
- Attention: Use particular care when dealing with installed components (camera
module, temperature control, swivelling/tilting drives, adapters, mechanics, etc.)
fixed above the mounting adapter on the cable and supply flange gland).
Risk of damage to the device and drifting of the optical axis!
- Attention: When removing the flange, ensure that the black O-ring seal in the
groove does not get damaged or dirty!
Fig. 6-7: Position of the O-ring seal, type T08-TNXCD
- After the completion of the work at the components installed in the camera, imme-
diately re-close the housing. Ensure that no foreign bodies and particles are en-
trapped in the housing!
- For closing the housing, proceed in reverse order as when opening. Please ad-
here to the following safety warnings:
Attention!
Screw the cover flange up to the end position, in order to ensure igni-
tion protection and the protective level (IP) of the housing.
Attention!
Tighten the flange by hand (no tightening torque is specified for this
purpose).
Attention!
Ensure that you do not damage the thread surface of the flame-proof
gap.