Doc.-ID: 180731-PT08BAU-SS-Ex Installation Manual rev.00.docx, Page 14 of 24
Attention!
If the bolted connections are tightened too strongly, it can cause dam-
ages to the device!
Attention!
Do not to damage the surface of the drill hole and the shaft (fitting) of
the flame-proof gap.
Attention!
Ensure that you do not damage the housing seals. Keep them clean.
Attention!
If the fitting gap is mechanically damaged, it is no longer allowed to
use the housing!
Attention!
Ensure that no foreign objects are entrapped in the housing.
- Exclusively use undamaged and clean
original screws
included in the supply.
The dismantled screw locks (spring washers DIN 127A) must be used again.
- The Gylon gasket must be used in undamaged condition, according to the flange
hole pattern. The surface orientation is arbitrary.
- If, when closing the housing, you notice that the surface of the fitting gap is dirty or
insufficiently lubricated, clean it with a clean cloth and suitable cleaning agent (e.g.
concentrated isopropyl alcohol) and then grease it with lubricant which is suitable
for this specific application.
- The
M4 screwed connections
of the
VA1.x
and the
V2.x
flange and body com-
ponents require a torque of
3.0 Nm
(
tighten crosswise!)
The
M6 screwed connections
of the
VA4.x
flange and body components must
always be tightened
crosswise
with a torque of
8.0 Nm
!
Do not tighten the screws too strongly! It can cause rupture of the cylinder head
and thus lead to an impairment of the pressure resistance or ignition protection
class of the camera housing.
Summary of Contents for ExCam Series
Page 1: ...ExCam Series T08 Installation Manual 2018...
Page 22: ...Doc ID 180731 PT08BAU SS Ex Installation Manual rev 00 docx Page 22 of 24...
Page 23: ...Doc ID 180731 PT08BAU SS Ex Installation Manual rev 00 docx Page 23 of 24...
Page 24: ...Doc ID 180731 PT08BAU SS Ex Installation Manual rev 00 docx Page 24 of 24...
