Instruction manual
Fodder wagons OptiFEED
3
3.
SAFETY RULES
Most of the accidents stem from inappropriate exploitation of the machine or inadequate
knowledge of machine’s working principles. Fodder wagon cannot be designed in such a way to
guarantee full safety as well as high work effectiveness. With that in mind, it is crucial that the user
uses the machine in appropriate way and do not cause any danger to himself or other people.
Machine requires knowledgeable person to service it. That is why it is necessary to read this manual
carefully before connecting the wagon to a tractor. Never leave the machine under the care of
people with insufficient knowledge about safe handling of the wagon.
3.1.
CONDITIONS OF THE MACHINE USE
1.
Read the manual before turning on the machine.
2.
Before each use, make sure that all covers are in good condition and whether the labels are
legible.
3.
Machine was designed and created to crumble, mix and distribute animal feeding products.
4.
Machine can only be operated by a qualified person in possession of a driving license
category T.
5.
Before fodder can be removed from the wagon, it is advisable to use proper equipment and
keep safe distance.
6.
Before using the fodder wagon, the driver has to make sure that no bystander is near
machine’s working space.
7.
When in danger, stop the machine immediately.
8.
In case of mechanical failure, the driver should stop the tractor immediately, pull the keys
from the ignition, and leave the vehicle to check for the cause of the failure and the extent of
damage. Damaged cover should be replaced.
9.
The driver has to be well rested and cannot be intoxicated or under the influence of drugs.
10.
The driver has to check beforehand for extraneous matter (metal, rocks) that can potentially
hurt other people, damage the machine or end up in the fodder.
11.
The machine is to be used only on farm, on a flat surface with good visibility and a place to
maneuver.
12.
During the loading and mixing the fodder, the driver should be wearing dust mask in order
to protect air passages. It is not necessary if the driver is in a locked cabin.
3.2.
GENERAL SAFETY INSTRUCTIONS
Information below is a brief reminder of general procedures that should assure driver’s
safety.
1.
Keep hands away from moving parts.
2.
Do not climb the machine while it is working.
3.
Do not maneuver violently.
4.
Before any repairs, turn off the engine, disconnect power take-off and take out the keys from
the ignition.
5.
Mount all the covers before you start up the machine again.
6.
Do not let anyone climb the machine while it is working.
7.
Do not repair or regulate the machine while it is working.
8.
Power take-off revolutions cannot exceed 550rpm.
9.
Do not go faster than 25km/h.
10.
Always disconnect power take-off, put parking brakes on and turn off the engine before:
Lubricating the machine,