18
Interrupting the milling process:
When the hopper is full of very hard kernels like corn, rice or winter wheat, it can
prevent the motor from starting in the finest setting. Should the motor be blocked
turn the adjustment screw to a coarser setting until the motor starts to turn and re-
adjust in the clockwise direction to the desired finer setting.
When milling very hard grain or corn do not interrupt the milling process!
Opening the milling chamber
:
Caution
:
Always disconnect the mill ‘s
power cord from the electrical outlet
before opening the milling chamber! Danger of injury!
The upper part of the mill is attached to the motor block by means of a bayonet
connection. The two fixing screws are on the left hand and right hand side on the
motor plate.
In order to open the milling chamber, hold the appliance by its lower
part and
turn the funnel approx. 2 cm in the anti-clockwise
direction.
If necessary slight, millimetre wise movements to the left and right
can be applied.
Closing the milling chamber:
Please clean the milling chamber and the support plate from any eventual flour
residue before replacing the funnel (use a brush to do so).
Take care that the
milling stones are positioned at the coarsest setting.
Place the hopper in a straight position onto fixing screws on the bottom part of the
mill so that there is no free space between the two parts.
Turn the funnel approx.
2 cm in the clockwise direction
until you can feel a clear resistance.
The two red marking points on the upper part of the mill and the motor block
should now be positioned exactly over each other
. This will enable you to control
whether the appliance has been closed correctly.
Summary of Contents for MT 5
Page 27: ...27 ...
