55
VS20WRF and VS20BRF Installer Manual
Calibration Procedure
8
After saving your setting, if your system has multiple thermostats the App will
display the confirmation shown below.
To exit to the
Dashboard, press
on the SALUS
logo on top of the
screen.
7
8
Adaptive learning mode
Using G30 and the iT600 App
1
Using G30 manually
3 sec.
3 sec.
3 sec.
x4
x5
x8
Press until you reach
PS49
G30 gateway you can manually update your coordinator to the latest version by
using the utility tool (software update).
This thermostat, paired with the SALUS TRV10RFM has a feature called Adaptive
days after installation to ensure you get the best combination of comfort and
For systems without the SALUS RX10RF boiler receiver
Adaptive learning mode will start automatically. When adaptive learning mode
is active the thermostat will show III CAL on the bottom of the device and will
warm your radiators up slightly this is perfectly normal, if you would rather not
use this feature you can disable please see below.
For systems with the SALUS RX10RF boiler receiver
want to us the adaptive learning mode please follow the steps below, please
note If you select this you will notice that as well as III CAL being displayed your
is perfectly normal.
Note - Once the system has fully learned then the thermostat will only be on
when required.
Using UGE and the Smart Home App
D05
1-> Auto-detection
2 -> Manual calibration
49
To exit to the Dashboard, press on the SALUS logo on top of the screen
After saving your setting, if your system has multiple thermostats the App will
7
