33
VS20WRF and VS20BRF Installer Manual
Installation - Pairing with Wiring Centre
Wiring
Centre
Pairing without Internet connection using a
CO10RF or a UG600/UGE600
1
The Zigbee coordinator or the Universal Gateway must be in
pairing mode. Hold the button for five seconds until it flashed red.
2
Ensure the wiring centre and optional system receiver
(Configured to RX1) for remote boiler switch are powered up.
Note: The wiring centre and system receivers will automatically join Zigbee network when
powered up and the Zigbee coordinator is in pair mode. Green LED on Wiring Centre and
Red LED on RX1 will go steady when the devices have joined the Zigbee network.
3
If more than one wiring centre is in the system, establish and note the wiring
centre number by pressing the pair key for 1 second. The wiring centre number
will flash.
If you have the KL08RF wiring centre, the CO10RF
coordinator plugs directly into the wiring centre if
you are using it without a Universal Gateway.
*Set your system parameters by
following the steps on pages 5-6.
5 sec
5 sec
