SUN_IS_ electrical_installation_v5.1_06092021
5
List of activities:
I.
PREPARATION OF PROTECTIVE PIPES AND HARNESSES
1.
To prepare harness "1" – cut the wires according to the specifications below:
2x 0.75 mm
2
, 400 cm – for the SOS switch
2x 0.75 mm
2
, 470 cm – to door lock sensor HUUM
4x 0.75 mm
2
, 470 cm – for HUUM Wi-Fi controller
2x 1.50 mm
2
, 470 cm – for the LED lighting supply
2. Arrange and tape the wires as shown in the picture, then wrap them all around – this will make it
easier to lead them through the protective pipe without any problems.
3. P
Run the harness through the wire and attach the protective pipe "1A". Leave the wire for the SOS button
out of the "1A" wire.
4. Insert wire 3 into the protective pipe "3".
5. Insert wire 4 into the protective pipe "4".
6. Prepare the furnace power cable "5". Measure 18 cm and, using a stripper, remove the
insulation.
Summary of Contents for SunCube
Page 1: ...OWNER S MANUAL Salus SunCube Sauna...
Page 2: ......
