SUN_IS_ electrical_installation_v5.1_06092021
24
XII.
MOUNTING THE WI-FI HUUM CONTROLLER
1. Crimp the cable lugs on the wires to the controller and screw the wires according to the
diagram below to the HUUM controller:
Connector 1 – brown wire
Connector 2 – ash wire
Connector 3 – green-yellow wire
Connector 4 – black
2. Check the attachment of the wires to the sensor, and tighten the fixing screws if necessary.
Secure the contacts with PVB varnish.
3. When dry, push the wire into the paneling. Remove the round cap, level the controller,
and drill the holes using a 2.5 mm drill bit. Then, using two stainless steel screws phi 3 mm,
length 30 mm, fasten the controller to the paneling and attach the round cap.
Summary of Contents for SunCube
Page 1: ...OWNER S MANUAL Salus SunCube Sauna...
Page 2: ......
