Tel: 886.2.2175 2930 Email: [email protected]
www.salukitec.com
141
Section 3 Description of Channel Scanner Menu
1
Sweep menu
Ch Scanner >
Sweep
Freq Scanner >
List Scanner >
·
[Channel Scanner]:
Press [Sweep]→ [Channel Scanner], set the channel
scanner mode and activate [Channel Scanner] menu. You can the channel
parameters in [Channel Scanner] menu. Refer to [Channel Scanner]
menu.
· [Freq Scanner]:
Press [Sweep]→ [Freq Scanner], set the frequ
ency
scanner mode and activate [Freq Scanner] menu. You can the channel
parameters in [Freq Scanner]. Refer to [Freq Scanner] menu.
· [List Scanner]:
Press [Sweep]→ [List Scanner], set the list scanner mode
and activate [List Scanner] menu. You can the channel parameters in
[List Scanner]. Refer to [List Scanner] menu.
2
Channel Scanner menu
Signal Std
--
Ch Scanner
Start Channel
--
Channel Number
Channel Step
1
Channel BW
200.000kHz
>
·
[Signal standard]:
Press [Sweep]→ [Channel Scanner]→ [Signal Std],
and the existing signal standard list will pop up, including relevant menus
such as [Head], [Tail], [Page Up] and [Page Down]. Click [Done],
and select the corresponding signal standard.
· [Start Channel]:
Press [Sweep]→[Channel Scanner]→[Start Channel],
and set the number of the starting channel. In this case, the starting channel
will be the initial channel of measurement and cannot be set until the signal
standard is selected.
· [Channel quantity]:
Pr
ess [Sweep]→ [Channel Scanner]→ [Number of
Channels], and set the number of measured channels. At most 20 channels
can be measured.
· [Channel Step]:
Press [Sweep]→ [Channel Scanner]→ [Channel Step],
and set the step between the measured channels.
· [Channel bandwidth]:
Press [Sweep]→ [Channel Scanner]→
[Bandwidth], and set the bandwidth of the measured channel.
