Tel: 886.2.2175 2930 Email: [email protected]
www.salukitec.com
128
Section 3 Description of AM-FM-PM Analyzer Menu
1
Frequency menu
Center Freq
Freq
Span
Start Freq
Stop Freq
Step Freq
Auto
Man
Signal Std
--
Channel
--
>
>
[Center Freq]:
Press [frequency]→[Center Freq] and set it with the number
keys on the front panel. Then select [GHz], [MHz], [kHz] or [Hz] in the
frequency unit menu, or set the center frequency with the [↑] or [↓] key or knob.
[Special note]:
When the [↑] or [↓] key or
knob is applied, the frequency
step should be the same as the set value of [Step Freq]. You can set the step
frequency with the number keys or [↑] or [↓] key or knob after changing
[CF Step Auto Man] into [CF Step Auto Man].
[Span]:
Press [frequency]→[Spa
n] to activate the span menu. Set the span with
the number keys, and select the frequency unit, or set the span with the [↑] or [↓]
key or knob. Refer to [Span] menu description for details.
[Special note]:
When the span is changed with the [↑] or [↓] key
or knob, the
step should be 1-2-5.
· [Starting frequency]:
Press [Frequency]→[Start Freq], and set the starting
frequency with the number keys on the front panel. Select the corresponding
frequency unit or set the starting frequency with the [↑] or [↓] key
or knob.
[Stop Freq]:
Press [frequency]→[Stop Freq], and set the stop frequency with
the number keys on the front panel. Select the corresponding frequency unit or
set the stop frequency with the [↑] or [↓] key or knob.
[Signal Std]:
Press [frequency]→[Si
gnal Std], and relevant soft menus will pop
up, including [Head], [Tail], [Page Up], [Page Down] and [Done]. Select the
related signal standard, and recall it with [Done] or [ok] in the menu.
[Special note]:
When the signal standard is applied, the center frequency
and span will be set as those defined in the signal standard.
[Channel]:
Press [frequency]→[Channel], and the channel setting dialog box
will pop up. Set the channel with the number keys or [↑] or [↓] key or knob.
[Special note]:
The channel should be set based on the applied signal
standard; otherwise, the prompt that setting is not allowed will pop up.
