ESDB-GUIDE-ENG- 02-21
www.saltosystems.com
SALTO Systems - Universal Energy Saver manual
9
CONFIDENTIAL - This document contains confidential and privileged information.
The reproduction of any part of the document is strictly prohibited without the prior written consent of SALTO Systems S.L.
2. With the Energy Saver in Synchronizing Mode, press the Detector’s inner button
(see Detector section).
3. The Detector’s LED will now go red, and the Detector and Energy Saver will now
begin to synchronize. When thesynchronization process has been successfully
completed, the Detector will blink red for a couple of seconds, followed by four slow
blinks and the LED will go off.
4. Repeat these steps for all the Detectors that need to be synchronized to the same
Energy Saver.
5. Once all the Detectors are synchronized, remove the Synchronizing Card from the
Energy Saver to exit Synchronizing Mode.
Please note that this same Synchronization Card can be used for the synchronization of
each room’s devices.
IMPORTANT! Synchronize each detector one at a time. Do not synchronize
several energy savers at the same time.
3.2 Special card kits
The following cards are included in the kit:
• Synchronizing Card.
It is used to put an Energy Saver in Synchronizing Mode
(LED blinks amber) and synchronize with the Detectors in the same room.
• Sensor Deleting Card.
It is used to desynchronize a room’s Energy Saver from the
Detectors in the same room. (LED blinks green to indicate the number of Detectors
desynchronized from the Energy Saver.) The Energy Saver is now ready to be
synchronized with new Detectors.
• Motion Detector Time Card (15 min).
It is used to change the lightning (relay 1)
motion detection time to 15 minutes. Once a door is closed, the Motion Detector
search for motion in the room for the next 15 minutes before shutting off.
• Motion Detector Time Card (60 min).
It is used to change the lightning (relay 1)
motion detection time to 60 minutes. Once a door is closed, the Motion Detector
search for motion in the room for the next 60 minutes before shutting off electricity.
