Sakai SV510-III, Shop Manual

Page: 109 / 248

6-020
VIBRATORY DRUM • REAR AXLE
2-3-2. Reassembly of vibratory drum
Before reassembling, clean disassembled parts well and
check that there is no abnormality.
When removed bolts threaded with thread sealant, replace
new bolts.
WARNING
When standing the vibratory drum, use wooden blocks
of sufficient strength to securely support the drum.
1) Lift vibratory drum (1) with a crane and put it in an upright
position.
(1) Vibratory drum
SV510D- : 3,060 kg ( 6,746 lbs.)
SV510T- : 3,385 kg ( 7,463 lbs.)
SV510TF- : 5,755 kg (12,687 lbs.)
2) Apply a thin coat of gear oil to axle shaft (43) on its
surface where vibrator bearing (4) will be press-fitted.
Drive in vibrator bearing (4).
(NOTICE)
Take care not to damage the bearing when installing
it.
3) Apply grease to entire periphery of O-ring (40).
Install O-ring (40) on axle shaft subassembly (43).
•
•
•
•
•
SV510- -06045
1
Wooden block
SV510- -06045
1
Wooden block
SV510- -06041
4
Wooden block
43
SV510- -06041
4
Wooden block
43
SV510- -06042
40
43
SV510- -06042
40
43