H1 Series
- 4 -
1.3 Target Group
Only qualified electricians who have read and fully understood all safety
regulations contained in this manual can install, maintain and repair the
inverter. Operators must be aware of the high-voltage device.
Chapter 2 Preparation
2.1 Intended Use
The product is not suitable for supplying power to life-support medical
equipment.
Loads connected to the product must have a CE identification label.
The maximum DC input voltage of the product must not be exceeded. Turn
off DC switch before any installation and operation.
2.2 Safety Instructions
DANGER
· There is possibility of dying due to electrical shock and high voltage.
· Do not touch the operating component of the inverter; it might result in burning or
death.
· To prevent risk of electric shock during installation and maintenance, please make
sure that all AC and DC terminals are plugged out.
· Do not touch the surface of the inverter while the housing is wet, otherwise, it
might cause electrical shock.
· Do not stay close to the inverter while there are severe weather conditions
including storm, lighting, etc.
· Before opening the housing, the SAJ inverter must be disconnected from the grid
and PV generator; you must wait for at least five minutes to let the energy storage
capacitors completely discharged after disconnecting from power source.
Summary of Contents for H1 Series
Page 1: ...H1 Series 0...
Page 35: ...H1 Series 34 5 8 Connection Diagram Figure 5 18 H1 Connection diagram...
Page 68: ...H1 Series 67...
