SAINT-GOBAIN Norton Clipper CG180, Operating Instructions Manual

Page: 7 / 12

8
For grinding works right into edges of the wall one segment of the dust
guard can be removed by means of the chucking device. This allows
grinding on surfaces which are usually hard to reach.
For it loosen both wing screws and pull the segment off (see fig. below).
Attention! All other grinding works have to be done with the complete
closed dust guard.
Attention!
The grinding wheel might heat up enormously during operation. You
could burn your hands or get cut or ripped by the segments.
Therefore, always use protective gloves when changing the grinding
wheel.
Before any work on the tool, disconnect the plug from the mains!
First of all, the detachable hood segment has
to be removed.
For it loosen both wing screws and pull the
segment off.
Through the opening at the protection cover
now you can hold up the driving disc between
gearbox and grinding wheel by using the jaw
wrench 32 included in the delivery.
Use the face spanner to unscrew the driving
nut.
Then remove the mounted grinding wheel
respectively mount the new one.
Changing the Diamond Grinding Wheel