23
GENERAL
1.
Make sure all power sources are off and the truck mounted PTO controls are disengaged
before attempting any maintenance procedures.
2.
Check for loose nuts and bolts, check for slack and condition of chains and belts, and check
for oil leaks especially after the first few days of operation.
3.
Check the condition of the blowing hose and for any build-up of material.
4.
Keep the machine clean.
DAILY
1.
Check and clean the blower air inlet screen and industrial engine cooling air inlet screen
truck body flange as required during operation. Keep these screens clean.
2.
Visually inspect and remove any foreign objects that may have entered the
machine such as pieces of bag, rags, razor knife, etc.
3.
Make sure safety system is functional.
4.
Check that the shredder area inspection window is not cracked.
Remove any foreign material wrapped around the shredder shaft.
5.
Check oil level in industrial engine.
WEEKLY
1.
Check for slack and condition of the PTO drive belts from under the truck.
2.
Check chain and belt tension on the machine.
3.
Very important
– grease the PTO drive pillow block bearings two to three pumps from
a hand operated gun. See bearing section for proper grease.
4.
Check the oil level in the blower, transmission, and gearbox.
Summary of Contents for CertainTeed Volu-Matic 200
