MF 6990dn - Agoris C935
- 9 -
2 -
Installation
Installation
Packaging contents
The packaging contains the components listed below:
•
Multifunction printer
•
Apron
•
1 installation guide
•
1 User manual CD-ROM
•
1 installation CD-ROM for PC
•
1 mains cable
•
1 telephone cable
•
1 consumable leaflet
Installing the machine
The machine is supplied in two boxes. Check the contents
of each box.
1
Unpack the printer part and remove all protective
spacers and adhesive tapes, as illustrated in the in-
stallation guide.
2
Install the printer in a suitable place respecting the
safety instructions described in the section Safety
[
119].
3
Place the document output tray on the printer and
remove the protective plastic film from the screen.
4
Remove the protective spacers inside the printer,
as illustrated in the installation guide.
5
Unpack the scanner and remove all protective
spacers and adhesive tapes, as illustrated in the in-
stallation guide.
6
Take hold of the scanner by the handles and place
it on the printer, aligning the studs in their housing,
as illustrated in the installation guide.
Installing options
Finisher
Consult the installation guide supplied with this option for
installation instructions.
Additional paper tray
Consult the installation guide supplied with this option for
installation instructions.
Perfume diffuser
The perfume unit is an option enabling you to install a
perfume diffuser on the machine. When this option is
installed and activated, the machine diffuses perfume
every hour, and for a period of time defined by you.
Consult the installation guide supplied with this option for
installation instructions.
To activate and configure this option, consult the section
Perfume setting [
25].
Memory extension
The machine is equipped with a 512 Mb RAM memory. It
is possible to add a 256 Mb memory extension.
Before installing the memory extension, read carefully the
instructions for antistatic protection.
Antistatic protection
•
Firstly, switch off the machine by pressing the On/Off
button (position 0) and disconnect the mains cable.
•
Disconnect all cables connected to the machine.
•
If you are wearing an antistatic bracelet, attach one of
the straps to your wrist and the other to the bare metal
frame located at the rear of the machine.
Never attach a strap to the machine when switched
on.
Plastic, rubber, wood, painted metal surfaces and tel-
ephone jacks are not sufficient earthing materials.
•
If you are not wearing an antistatic bracelet, discharge
any static electricity from your body by touching a sur-
face connected to the earth before handling the board
or any electronic components in the machine.
Try not to move around too much after earthing your-
self.
Caution
Before installing any options, the machine
and the option to be installed must be swit-
ched off and disconnected from the mains
power supply.
WARNING
The machine's electronic board must be
protected from any electrostatic damage
that may be caused by handling.
