15
INSTALLING AND USING THE TERMINAL FOR THE
FIRST TIME
This equipment has to be imperatively installed, tested and serviced by
qualified personnel. After installation or service, the cover must imperatively be closed
and fastened to base with the tie or the screw provided by the manufacturer, in order to
ensure end user safety against electric shocks.
No operator serviceable parts. Refer servicing to qualified personnel. To prevent electric
shocks, do not remove cover.
Connecting line / battery / power supply
The various accessories supplied have to be installed carefully before powering the
equipment.
Configuration of P2
Point
Position of the button
of P2
1
A: Internal antenna (
Position by default
)
B: External antenna
2
A: Power supply disabled
B: Power supply enable (
Position for
operation
)
3
Reserved
4
Reserved
A
A
A
A
B
B
B
B
1
2
3
4
Configuration of the terminal
1. Disconnect the power supply.
2. Open the cover of the terminal.
3. Check if the battery is connected (the plug
must be inserted in connector P1).
4. If the battery is connected go to step 6.
5. Connect the wire connecting the battery
to connector P1, on the printed circuit
board of the terminal.
6. Configure DIP switch P2 as indicated in
figure below.
7. Close the cover of the terminal.
8. Fasten to the base with the tie or screw
provided.
Installing your terminal
!
ZAMBUUUJO.p65
10/04/02, 18:45
15
