Sagem MF9300, Scanner Manual

Page: 19 / 46

17
BEFORE USING THE NETWORK SCANNER FUNCTION
1
RESTRICTING USE OF THE NETWORK SCANNER
FUNCTION (USER AUTHENTICATION)
Use of the network scanner function can be restricted by means of user passwords stored in an LDAP server.
Settings required for user authentication
To implement user authentication, the following settings are required:
• Enable user authentication (step 3 on page 6)
• Configure LDAP server settings (p.8)
• Store login names (p.15)
Logging in when user authentication is enabled
To use the network scanner function when user authentication is enabled, you must first log in. Follow these steps:
1
Press the [SCAN] key on the operation
panel.
The login screen will
appear in the touch
panel.
2
Touch the [LOGIN NAME] key.
3
Touch a login name key and then
touch the [OK] key.
4
If a password has been established
for the selected login name, touch the
[PASSWORD] key.
5
Enter the password.
For the password, enter the user password that is
stored in the server.
6
Touch the [OK] key.
If the login name and
password are valid, the
initial screen (p.18) of
scanner mode appears.
PRINT
SCAN
FAX
ON LI
DATA
DATA
DATA
LINE
ENTER LOGIN NAME AND PASSWORD.
LOGIN NAME
PASSWORD
1/2
OK
ABC GROU
JKLMN GHI OPQRST UVWXYZ
arp002
arp001
arp003
Sharp001
ENTER LOGIN NAME AND PASSWORD.
LOGIN NAME
PASSWORD
SPACE 12#$%
abc ABC
AB/ab
CANCEL OK
PASSWORD
ACE
abc ABC
CANCEL OK
12#$% AB/ab
To switch to a mode other than network scanner mode, you must log out.
Note